Program Wayne-Dalton Remotes
Wayne Dalton manufactures a complete line of garage doors and door openers. Although Wayne-Dalton uses Genie openers, they also have their own unique line. Programming a new Wayne-Dalton remote requires activating the remote control before programming the opener. Wayne-Dalton remotes are available exclusively through Wayne-Dalton and Wayne-Dalton authorized dealers. Unlike many openers, the iDrive line has a slimmer power head and the programming button is on the side.
Instructions
1. Press and hold the large button below the smaller ones with your finger. The red LED lights on the control blink rapidly for two seconds and then stay on continuously when the control is activated successfully. Release the button.
2. Set a step ladder under the Wayne-Dalton garage door opener motor head. Press the red Learn button on the side or bottom of the motor head depending on which unit you own. An LED light blinks on the Quantum Classic and Doormaster openers. A single beep emits from the iDrive line of openers.
3. Press and hold one of the smaller buttons on the transmitter. The LED light on the opener will turn off or you will hear a single beep depending upon the opener. Release the button.
4. Continue setting the transmitter for Doormaster units only. Press and release the button again. The LED light will blink and then turn off.
Tips Warnings
As a precaution, pull the emergency cord to release the door from the opener during programming.
