Kenmore Dishwasher model# 587

My dishwasher will start to fill but then the water will just drain out of the bottom. When the pump turns on there is not enough water to do anything. Any suggestions? Sounds like it is siphoning.. do you have the drain hose going to a air gap.. and also it needs a high loop to keep from draining back fm the sink This has been working fine for the past 3 years. Now all a sudden it started just draining??????????? you got a model # should be on the tag inside by door seal Dishwasher model# 587 kenmore 587.14249991 Check valve may have something keeping it open .. you will have to disassemble the pump to see if anything in there.... sears.com in the parts are put model number in and it will show you a exploded view of the pump... My dishwasher pump makes a loud high pitch noise and smells like something is burning plastic or rubber. I'm trying to disassemble the impeller stack to check for damage and the screw holding the upper impeller is really tight. I don't want to force it the wrong direction and I can't from the limited documentation if the screw is right-hand or left-hand threads. Can you tell me if it loosens counterclockwise or clockwise? Thanks Regular threads counter-clockwise Thanks so much! I'm still trying to complete the repair on my Kenmore dishwasher model above. Thanks to help from Bambiblaster, I was able to successfully remove the screw holding the upper impeller in place and have disassembled everything down to the lower impeller. The lower impeller does not appear to be damaged but I would like to remove it and replace the seal. I can't figure out what is holding it in place. I have tried lifting it out by pulling up on the stem with pliers and tried rocking back and forth with no success. Is it threaded on? Can you tell me the proper removal technique? Thanks! Kenmore model 587.15152401. Food particles dried up to dishes. Dish detergent dried up in main and preliminary door compartments. Heating element is on during washing cycles. Dishes are very hot after washing.. Is this normal? Normal cycle selected. Water presser is good. Arms are spraying water. Draining well. Could any body help me to isolate the problem? Thanks, IK

Related Posts:

• 
  Kenmore dishwasher door leak
  
  Kenmore dishwasher door leakI have a Kenmore dishwasher that is leaking water from the front door in the lower right hand corner. I have already tried the following to remedy the situation. - Veri...
  


• 
  Kenmore ultra wash dishwasher model 66515819990
  
  Kenmore Ultra Wash Dishwasher Model 665-15819990Unit will not drain..I have checked the drain line at the machine and it isn't clogged. The unit works fine until it goes into the drain cycle then...
  


• 
  Kenmore elite 665 series dishwasher cancel button flashing
  
  Kenmore Elite 665 series Dishwasher cancel button flashingThis dishwasher is about 2 years old. I purchased it new. It's been perfect up until 2 days ago. A cycle was just finishing (I do Normal W...
  


• 
  Kenmore elite electric he3 model 11082822102 wont heat
  
  kenmore elite electric he3 model 110-82822102 wont heat!My dryer went on the fritz yesterday...no heat. Everything else works...I tried cutting power to re-set, checking for plugs, and using diffe...
  


• 
  Ge dishwasher will not pump out water
  
  GE Dishwasher will not pump out waterThis is a 3 year old GE Dishwasher that will not drain water from the bottom. The water rests just above the heated dry. GE Model # GSD3200G00BB I checked the...