The Gettys N350 Servo Drive is a three-phase, half wave amplifier/controller for servo motors found inside industrial shop machines, like lathes. The Getty's N350 features a line-to-line voltage rating of 240-300 volts of alternating current and a servo motor with 33-amp rating. The servo drive is essentially a type of rectifier that converts alternating current to direct current. Installing the Gettys N350 servo drive takes approximately 30 minutes to slightly over an hour.
Instructions
1. Unplug the power cord to the shop machine the Gettys drive is installed in.
2. Remove the front panel from the lathe or shop machine with a Phillips screwdriver.
3. Slide the old servo drive from its bus slot by pulling it upwards. Slide the Gettys N350 into the now-empty bus slot, or port.
4. Hold the access panel back in place and replace the retaining screws with the screwdriver.
5. Plug the lathe or shop machine back into an electrical outlet.
Tags: Gettys N350, shop machine, alternating current, Gettys N350 Servo, lathe shop, lathe shop machine