Batteries in electronic devices can be charged for a certain number of cycles before they lose their charging capacity. When you see that your Palm Zire 72 is no longer holding a charge, the battery needs to be replaced. Authorized technicians and service centers can replace the battery under warranty, or you can purchase a battery kit for the Palm Zire 71 or 72 and replace it yourself. With all electronic devices, make sure you take precautions handling the parts and batteries. Don't forget to back up your data before disassembly.
Instructions
1. Place the PDA face down on the cloth to protect the display. Using the T5 screwdriver, remove the two screws at the bottom and the single screw holding the mesh cover, and set aside. Remove the mesh cover and the two screws underneath it, and set aside.
2. Pry open the case using the plastic screwdriver, starting at the top and moving around the sides until the back cover can be lifted off. Make sure the back cover is still attached to the ribbon cable, and set aside (do not detach the ribbon cable).
3. Locate the silver battery case at the top of the PDA; look for a small white connector attached to two wires. Disconnect the connector by carefully pulling the connector up (you may use the plastic tweezers). Remove the battery carefully (you may use the plastic screwdriver).
4. Place the replacement battery in the same orientation as the original battery. Connect the white connector to the new battery. Do not force the pieces into place, if they are misaligned.
5. Check the position and placement of the replacement battery and connector. Position the back cover and gently press into place. Insert the two screws, and tighten with the T5 screwdriver.
6. Charge your battery completely for three hours before using.
Tags: back cover, Palm Zire, electronic devices, into place, mesh cover, plastic screwdriver, replacement battery