A toggle switch allows musicians to produce varied sound from their amplifiers. Installing a single-throw toggle switch only requires a few simple steps.
Instructions
1. Remove the input jack from the face of the amplifier. Find the cables that run to the input jack from the power amp. Cut them at the place where you would like the toggle switch.
2. Attach the cables from the input jack to the middle conductor on the back end of the toggle switch. This configuration allows the toggle switch to behave in an on/off fashion. To attach the cables, twist them together then cover the exposed wire with electrical tape. This reduces the possibility of contaminates getting into your signal chain.
3. Take the cable still attached to the power amp and attach it to the opposite middle conductor on the toggle switch.
4. Re-attach the input jack to the face of the amp and plug in an instrument. If you hear sound, job well done. If not, check each cable connection. Failing that, use the volt meter on each cable to see if one has shorted out or is in the wrong position.
Tags: input jack, toggle switch, each cable, input jack from, jack from, middle conductor, toggle switch